The NT-series of plate brake testers analyses the brakes of a vehicle under dynamic conditions of each individual wheel for the service- and parking brake. The brake forces, difference left/right of an axle and the important brake force ratio front axle – rear axle can be measured. Long based vehicles can easily be tested as a result of the 1900mm brake plates.
With the integrated NTS sideslip meter, during the brake test, the dynamic toe-in or toe-out of an axle is presented on the display. The compensation plate relieves any built-up tire forces, which would impair the measurement. This guarantees an accurate sideslip test. The ST2001 suspension analyser completes the fully automatic test lane.
Two consoles are available for the NTS1900: 1503L and 4003L.
The Altus® 4003L is a large freestanding console. The 4003L is standard supplied with a 22-24” monitor, infra-red remote control hand set, PC-keyboard, electronics and software. It contains two compartments. One for a keyboard and optional printer. The second contains the electronics. A fully automatic test program is standard.
The Altus® 1503L is a monitor test lane console especially designed for wall mounting. The 1503L is standard supplied with a 22-24” monitor, pivoting wall bracket for monitor, infra-red remote control hand set, PC-keyboard, electronics and software. A fully automatic test program is standard.
End plates for in-floor configurations
ST2001 suspension analyser
Pedal force meter
Wall bracket for printer