The operator will usually perform a fully automatic test with the Altus® Test Lane. All tests follow automatically and in a logical sequence. A complete test can be performed in less than two minutes. Skip to Altus® BB software.

Immediately after the test, a summary test report will be shown on the monitor or on paper. Test, diagnosis and report, fast and automatically one after the other! Below an example of the main start screen, a service brake screen with pedal force and a total results screen.

A complete test can be performed in less than two minutes. Immediately after the test, a summary test report will be shown on the monitor or on paper. Test, diagnosis and report, fast and automatically one after the other! Below the testsequence of a complete test lane including a sideslip meter, weighing facility, suspension tester, brake tester with pedal force meter and speedometer. Back to Altus® PC software.

After completion of the front axle, the next step is the rear axle sideslip, suspension and service brake, followed by the parking brake. The next images show the overall brake forces as well as the overall results.

The test results on the screen and on paper are always clear and unambiguous: Red = Danger, Green = OK. Your client is easily convinced and will immediately understand if there is a problem. The operator can configure the tester to print a carefully edited test report immediately after finishing the test cycle: Numerical values, graphs or written diagnosis. Back to Altus® PC software.