RT900 Roller Brake Tester

Standard duty dual bed roller brake tester for passenger cars.

In addition to measuring the brake forces per wheel and the difference between the left and right sides, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel. Special attention has been given to prevent damage to the tires. The rollers are very quickly stopped when slippage occurs, even during the start-up of the motors. All moving components are supported by roller bearings for a long and trouble free service. The chassis is hot dip zinc.

A weighing system is available as an option. With this weighing facility, the deceleration (brake efficiency) of the vehicle will be calculated and can be compared with legal requirements for the service-, parking- and the emergency brake systems.

The RT900 can also be position ON FLOOR in front of a 4-post lift or on its own in combination with hot dip galvanised RAMPS.

Optional:
Cover plates (hot dip zinc)
8-point weighing system
Steel rollers
Single phase model
Set of ramps (L=2meter)(hot dip zinc)

Free run roller set (hot dip zinc)

Specifications:
Maximum axle load: 2.5 ton
Roller speed: 2.6 km/h
Brake force maximum: 6000 N
Rollers: 180 x 600 mm
Track: Variable
Power supply: 2 x 2.2 kW, 3 phase, 400 V, 50 Hz
Dimensions: 88 x 78 x 21.5 cm (one side)
Chassis: hot dip zinc

Brochures:
R501 Analogue Pointer Display For Car Brake Tester
L601 Analogue/Digital Display For Car Brake Test Lane
901L Digital Display For Car Test Lanes





Make a choice

Categories
- Cars
- Commercial vehicles
- Motorcycles
- Caravans & Trailers

Product Groups
- Combo testers
- Consoles for roller testers
- Emission testers
- Headlight testers
- Pedal force & Air pressure
- Plate brake testers
- Play detectors
- Roller brake testers
- Roller tester add-ons
- Sideslip meters
- Speedometers
- Suspension testers

Disclaimer | Copyright © 2018 Altus-Escon-Company BV, Inc. All Rights Reserved