Heavy duty roller brake tester for passenger cars, vans and light commercial vehicles.

In addition to measuring the brake forces per wheel and the difference between the left and right sides, the operator can determine the important quantities rolling resistance, actuation force, ovality (out-of-roundness) and brake fading for each wheel. Special attention has been given to prevent damage to the tires. The rollers are very quickly stopped when slippage occurs, even during the start-up of the motors. All roller brake testers are equipped with reliable worm gear motors. All moving components are supported by roller bearings for a long and trouble free service. The chassis is hot dip zinc.

A weighing system is available as an option. With this weighing facility, the deceleration (brake efficiency) of the vehicle will be calculated and can be compared with legal requirements for the service-, parking- and the emergency brake systems.

Optional:
Cover plates (hot dip zinc)
4-point weighing system
Steel rollers

Free run roller set (hot dip zinc)
Easy Exit® lift system (hot dip zinc) (in combination with 4200L, 1600L, 901L or L601).

	Specifications: Maximum axle load: 4 ton Roller speed: 5 km/h Brake force maximum: 8000 N Rollers: 206 x 700 mm Track: 800-2200 mm Power supply: 2 x 5.5 kW; 3 phase, 400 V, 50 Hz Dimensions: 234 x 66 x 30 cm Chassis: hot dip zinc Motor voltage and frequency other than 3 phase 400 V / 50Hz are available upon request. Brochures: R501 Analogue Pointer Display For Car Brake Tester L601 Analogue/Digital Display For Car Brake Test Lane 901L Digital Display For Car Test Lanes 901L Digital Display For Car Brake Tester BB Monitor Consoles for Car Test Lanes PC - Test Lane Consoles For Passenger Cars